avr32: Power Management support ("standby" and "mem" modes)
Implement Standby support. In this mode, we'll suspend all drivers,
put the SDRAM in self-refresh mode and switch off the HSB bus
("frozen" mode.)
Implement Suspend-to-mem support. In this mode, we suspend all
drivers, put the SDRAM into self-refresh mode and switch off all
internal clocks except the 32 kHz oscillator ("stop" mode.)
The lowest-level suspend code runs from a small portion of SRAM
allocated at startup time. This gets rid of a small potential race
with the SDRAM where we might try to enter self-refresh mode in the
middle of an icache burst. We also relocate all interrupt and
exception handlers to SRAM during the small window when we enter and
exit the low-power modes.
We don't need to do any special tricks to start and stop the PLL. The
main clock is automatically gated by hardware until the PLL is stable.
Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
diff --git a/arch/avr32/mach-at32ap/sdramc.h b/arch/avr32/mach-at32ap/sdramc.h
new file mode 100644
index 0000000..66eeaed
--- /dev/null
+++ b/arch/avr32/mach-at32ap/sdramc.h
@@ -0,0 +1,76 @@
+/*
+ * Register definitions for the AT32AP SDRAM Controller
+ *
+ * Copyright (C) 2008 Atmel Corporation
+ *
+ * This program is free software; you can redistribute it and/or
+ * modify it under the terms of the GNU General Public License
+ * version 2 as published by the Free Software Foundation.
+ */
+
+/* Register offsets */
+#define SDRAMC_MR 0x0000
+#define SDRAMC_TR 0x0004
+#define SDRAMC_CR 0x0008
+#define SDRAMC_HSR 0x000c
+#define SDRAMC_LPR 0x0010
+#define SDRAMC_IER 0x0014
+#define SDRAMC_IDR 0x0018
+#define SDRAMC_IMR 0x001c
+#define SDRAMC_ISR 0x0020
+#define SDRAMC_MDR 0x0024
+
+/* MR - Mode Register */
+#define SDRAMC_MR_MODE_NORMAL ( 0 << 0)
+#define SDRAMC_MR_MODE_NOP ( 1 << 0)
+#define SDRAMC_MR_MODE_BANKS_PRECHARGE ( 2 << 0)
+#define SDRAMC_MR_MODE_LOAD_MODE ( 3 << 0)
+#define SDRAMC_MR_MODE_AUTO_REFRESH ( 4 << 0)
+#define SDRAMC_MR_MODE_EXT_LOAD_MODE ( 5 << 0)
+#define SDRAMC_MR_MODE_POWER_DOWN ( 6 << 0)
+
+/* CR - Configuration Register */
+#define SDRAMC_CR_NC_8_BITS ( 0 << 0)
+#define SDRAMC_CR_NC_9_BITS ( 1 << 0)
+#define SDRAMC_CR_NC_10_BITS ( 2 << 0)
+#define SDRAMC_CR_NC_11_BITS ( 3 << 0)
+#define SDRAMC_CR_NR_11_BITS ( 0 << 2)
+#define SDRAMC_CR_NR_12_BITS ( 1 << 2)
+#define SDRAMC_CR_NR_13_BITS ( 2 << 2)
+#define SDRAMC_CR_NB_2_BANKS ( 0 << 4)
+#define SDRAMC_CR_NB_4_BANKS ( 1 << 4)
+#define SDRAMC_CR_CAS(x) ((x) << 5)
+#define SDRAMC_CR_DBW_32_BITS ( 0 << 7)
+#define SDRAMC_CR_DBW_16_BITS ( 1 << 7)
+#define SDRAMC_CR_TWR(x) ((x) << 8)
+#define SDRAMC_CR_TRC(x) ((x) << 12)
+#define SDRAMC_CR_TRP(x) ((x) << 16)
+#define SDRAMC_CR_TRCD(x) ((x) << 20)
+#define SDRAMC_CR_TRAS(x) ((x) << 24)
+#define SDRAMC_CR_TXSR(x) ((x) << 28)
+
+/* HSR - High Speed Register */
+#define SDRAMC_HSR_DA ( 1 << 0)
+
+/* LPR - Low Power Register */
+#define SDRAMC_LPR_LPCB_INHIBIT ( 0 << 0)
+#define SDRAMC_LPR_LPCB_SELF_RFR ( 1 << 0)
+#define SDRAMC_LPR_LPCB_PDOWN ( 2 << 0)
+#define SDRAMC_LPR_LPCB_DEEP_PDOWN ( 3 << 0)
+#define SDRAMC_LPR_PASR(x) ((x) << 4)
+#define SDRAMC_LPR_TCSR(x) ((x) << 8)
+#define SDRAMC_LPR_DS(x) ((x) << 10)
+#define SDRAMC_LPR_TIMEOUT(x) ((x) << 12)
+
+/* IER/IDR/IMR/ISR - Interrupt Enable/Disable/Mask/Status Register */
+#define SDRAMC_ISR_RES ( 1 << 0)
+
+/* MDR - Memory Device Register */
+#define SDRAMC_MDR_MD_SDRAM ( 0 << 0)
+#define SDRAMC_MDR_MD_LOW_PWR_SDRAM ( 1 << 0)
+
+/* Register access macros */
+#define sdramc_readl(reg) \
+ __raw_readl((void __iomem __force *)SDRAMC_BASE + SDRAMC_##reg)
+#define sdramc_writel(reg, value) \
+ __raw_writel(value, (void __iomem __force *)SDRAMC_BASE + SDRAMC_##reg)