[PATCH] PCI: PCIE power management quirk
When changing power states from D0->DX and then from DX->D0, some
Intel PCIE chipsets will cause a device reset to occur. This will
cause problems for any D State other than D3, since any state
information that the driver will expect to be present coming from
a D1 or D2 state will have been cleared. This patch addes a
flag to the pci_dev structure to indicate that devices should
not use states D1 or D2, and will set that flag for the affected
chipsets. This patch also modifies pci_set_power_state() so that
when a device driver tries to set the power state on
a device that is downstream from an affected chipset, or on one
of the affected devices it only allows state changes to or
from D0 & D3. In addition, this patch allows the delay time
between D3->D0 to be changed via a quirk. These chipsets also
need additional time to change states beyond the normal 10ms.
Signed-off-by: Kristen Carlson Accardi <kristen.c.accardi@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/include/linux/pci.h b/include/linux/pci.h
index 983fca2..8565b81 100644
--- a/include/linux/pci.h
+++ b/include/linux/pci.h
@@ -161,6 +161,7 @@
unsigned int is_enabled:1; /* pci_enable_device has been called */
unsigned int is_busmaster:1; /* device is busmaster */
unsigned int no_msi:1; /* device may not use msi */
+ unsigned int no_d1d2:1; /* only allow d0 or d3 */
unsigned int block_ucfg_access:1; /* userspace config space access is blocked */
unsigned int broken_parity_status:1; /* Device generates false positive parity */
unsigned int msi_enabled:1;