tg3: Use *_UNKNOWN ethtool definitions
This patch replaces tg3's private SPEED_INVALID and DUPLEX_INVALID
definitions with SPEED_UNKNOWN and DUPLEX_UNKNOWN respectively.
Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/tg3.c b/drivers/net/ethernet/broadcom/tg3.c
index 859bd22..302c69b 100644
--- a/drivers/net/ethernet/broadcom/tg3.c
+++ b/drivers/net/ethernet/broadcom/tg3.c
@@ -1819,8 +1819,8 @@
(6 << TX_LENGTHS_IPG_SHIFT) |
(32 << TX_LENGTHS_SLOT_TIME_SHIFT)));
- if ((phydev->link && tp->link_config.active_speed == SPEED_INVALID) ||
- (!phydev->link && tp->link_config.active_speed != SPEED_INVALID) ||
+ if ((phydev->link && tp->link_config.active_speed == SPEED_UNKNOWN) ||
+ (!phydev->link && tp->link_config.active_speed != SPEED_UNKNOWN) ||
phydev->speed != tp->link_config.active_speed ||
phydev->duplex != tp->link_config.active_duplex ||
oldflowctrl != tp->link_config.active_flowctrl)
@@ -3813,8 +3813,8 @@
DUPLEX_HALF;
break;
}
- *speed = SPEED_INVALID;
- *duplex = DUPLEX_INVALID;
+ *speed = SPEED_UNKNOWN;
+ *duplex = DUPLEX_UNKNOWN;
break;
}
}
@@ -3906,7 +3906,7 @@
tg3_phy_autoneg_cfg(tp, new_adv,
FLOW_CTRL_TX | FLOW_CTRL_RX);
- } else if (tp->link_config.speed == SPEED_INVALID) {
+ } else if (tp->link_config.speed == SPEED_UNKNOWN) {
if (tp->phy_flags & TG3_PHYFLG_10_100_ONLY)
tp->link_config.advertising &=
~(ADVERTISED_1000baseT_Half |
@@ -3938,7 +3938,7 @@
}
if (tp->link_config.autoneg == AUTONEG_DISABLE &&
- tp->link_config.speed != SPEED_INVALID) {
+ tp->link_config.speed != SPEED_UNKNOWN) {
u32 bmcr, orig_bmcr;
tp->link_config.active_speed = tp->link_config.speed;
@@ -4172,8 +4172,8 @@
}
current_link_up = 0;
- current_speed = SPEED_INVALID;
- current_duplex = DUPLEX_INVALID;
+ current_speed = SPEED_UNKNOWN;
+ current_duplex = DUPLEX_UNKNOWN;
tp->phy_flags &= ~TG3_PHYFLG_MDIX_STATE;
tp->link_config.rmt_adv = 0;
@@ -5069,8 +5069,8 @@
LED_CTRL_LNKLED_OVERRIDE |
LED_CTRL_1000MBPS_ON));
} else {
- tp->link_config.active_speed = SPEED_INVALID;
- tp->link_config.active_duplex = DUPLEX_INVALID;
+ tp->link_config.active_speed = SPEED_UNKNOWN;
+ tp->link_config.active_duplex = DUPLEX_UNKNOWN;
tw32(MAC_LED_CTRL, (tp->led_ctrl |
LED_CTRL_LNKLED_OVERRIDE |
LED_CTRL_TRAFFIC_OVERRIDE));
@@ -5118,8 +5118,8 @@
tg3_phy_reset(tp);
current_link_up = 0;
- current_speed = SPEED_INVALID;
- current_duplex = DUPLEX_INVALID;
+ current_speed = SPEED_UNKNOWN;
+ current_duplex = DUPLEX_UNKNOWN;
tp->link_config.rmt_adv = 0;
err |= tg3_readphy(tp, MII_BMSR, &bmsr);
@@ -10515,8 +10515,8 @@
cmd->eth_tp_mdix = ETH_TP_MDI;
}
} else {
- ethtool_cmd_speed_set(cmd, SPEED_INVALID);
- cmd->duplex = DUPLEX_INVALID;
+ ethtool_cmd_speed_set(cmd, SPEED_UNKNOWN);
+ cmd->duplex = DUPLEX_UNKNOWN;
cmd->eth_tp_mdix = ETH_TP_MDI_INVALID;
}
cmd->phy_address = tp->phy_addr;
@@ -10598,8 +10598,8 @@
if (cmd->autoneg == AUTONEG_ENABLE) {
tp->link_config.advertising = (cmd->advertising |
ADVERTISED_Autoneg);
- tp->link_config.speed = SPEED_INVALID;
- tp->link_config.duplex = DUPLEX_INVALID;
+ tp->link_config.speed = SPEED_UNKNOWN;
+ tp->link_config.duplex = DUPLEX_UNKNOWN;
} else {
tp->link_config.advertising = 0;
tp->link_config.speed = speed;
@@ -13347,11 +13347,11 @@
adv |= ADVERTISED_FIBRE;
tp->link_config.advertising = adv;
- tp->link_config.speed = SPEED_INVALID;
- tp->link_config.duplex = DUPLEX_INVALID;
+ tp->link_config.speed = SPEED_UNKNOWN;
+ tp->link_config.duplex = DUPLEX_UNKNOWN;
tp->link_config.autoneg = AUTONEG_ENABLE;
- tp->link_config.active_speed = SPEED_INVALID;
- tp->link_config.active_duplex = DUPLEX_INVALID;
+ tp->link_config.active_speed = SPEED_UNKNOWN;
+ tp->link_config.active_duplex = DUPLEX_UNKNOWN;
}
static int __devinit tg3_phy_probe(struct tg3 *tp)