libata: dev_config does not need ap and adev passing
It used to be impossible to get from ata_device to ata_port but that is
no longer true. Various methods have been cleaned up over time but
dev_config still takes both and most users don't need both anyway. Tidy
this one up
Signed-off-by: Alan Cox <alan@redhat.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/sata_sil.c b/drivers/ata/sata_sil.c
index 917b7ea..170d36e 100644
--- a/drivers/ata/sata_sil.c
+++ b/drivers/ata/sata_sil.c
@@ -114,7 +114,7 @@
#ifdef CONFIG_PM
static int sil_pci_device_resume(struct pci_dev *pdev);
#endif
-static void sil_dev_config(struct ata_port *ap, struct ata_device *dev);
+static void sil_dev_config(struct ata_device *dev);
static u32 sil_scr_read (struct ata_port *ap, unsigned int sc_reg);
static void sil_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val);
static void sil_post_set_mode (struct ata_port *ap);
@@ -521,7 +521,6 @@
/**
* sil_dev_config - Apply device/host-specific errata fixups
- * @ap: Port containing device to be examined
* @dev: Device to be examined
*
* After the IDENTIFY [PACKET] DEVICE step is complete, and a
@@ -548,8 +547,9 @@
* appreciated.
* - But then again UDMA5 is hardly anything to complain about
*/
-static void sil_dev_config(struct ata_port *ap, struct ata_device *dev)
+static void sil_dev_config(struct ata_device *dev)
{
+ struct ata_port *ap = dev->ap;
int print_info = ap->eh_context.i.flags & ATA_EHI_PRINTINFO;
unsigned int n, quirks = 0;
unsigned char model_num[ATA_ID_PROD_LEN + 1];