gpiolib: pca9539 i2c gpio expander support
This adds a new-style I2C driver with basic support for the sixteen bit
PCA9539 GPIO expanders. These chips have multiple registers, push-pull output
drivers, and (not supported in this patch) pin change interrupts.
Board-specific code must provide "pca9539_platform_data" with each chip's
"i2c_board_info". That provides the GPIO numbers to be used by that chip, and
callbacks for board-specific setup/teardown logic.
Derived from drivers/i2c/chips/pca9539.c (which has no current known users).
This is faster and simpler; it uses 16-bit register access, and cache the
OUTPUT and DIRECTION registers for fast access
Signed-off-by: eric miao <eric.miao@marvell.com>
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Acked-by: Jean Delvare <khali@linux-fr.org>
Cc: Sam Ravnborg <sam@ravnborg.org>
Cc: Haavard Skinnemoen <hskinnemoen@atmel.com>
Cc: Philipp Zabel <philipp.zabel@gmail.com>
Cc: Russell King <rmk@arm.linux.org.uk>
Cc: Ben Gardner <bgardner@wabtec.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index d924a32..74fac0f 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -27,6 +27,16 @@
comment "I2C GPIO expanders:"
+config GPIO_PCA9539
+ tristate "PCA9539 16-bit I/O port"
+ depends on I2C
+ help
+ Say yes here to support the PCA9539 16-bit I/O port. These
+ parts are made by NXP and TI.
+
+ This driver can also be built as a module. If so, the module
+ will be called pca9539.
+
config GPIO_PCF857X
tristate "PCF857x, PCA857x, and PCA967x I2C GPIO expanders"
depends on I2C