ncr5380: Update usage documentation
Update kernel parameter documentation for atari_scsi, mac_scsi and
g_NCR5380 drivers. Remove duplication.
Signed-off-by: Finn Thain <fthain@telegraphics.com.au>
Reviewed-by: Hannes Reinecke <hare@suse.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
diff --git a/Documentation/scsi/g_NCR5380.txt b/Documentation/scsi/g_NCR5380.txt
index 3b80f56..fd88015 100644
--- a/Documentation/scsi/g_NCR5380.txt
+++ b/Documentation/scsi/g_NCR5380.txt
@@ -23,11 +23,10 @@
If the default configuration does not work for you, you can use the kernel
command lines (eg using the lilo append command):
- ncr5380=port,irq,dma
- ncr53c400=port,irq
-or
- ncr5380=base,irq,dma
- ncr53c400=base,irq
+ ncr5380=addr,irq
+ ncr53c400=addr,irq
+ ncr53c400a=addr,irq
+ dtc3181e=addr,irq
The driver does not probe for any addresses or ports other than those in
the OVERRIDE or given to the kernel as above.
@@ -36,19 +35,17 @@
/proc/scsi/g_NCR5380/x where x is the scsi card number as detected at boot
time. More info to come in the future.
-When NCR53c400 support is compiled in, BIOS parameters will be returned by
-the driver (the raw 5380 driver does not and I don't plan to fiddle with
-it!).
-
This driver works as a module.
When included as a module, parameters can be passed on the insmod/modprobe
command line:
ncr_irq=xx the interrupt
ncr_addr=xx the port or base address (for port or memory
mapped, resp.)
- ncr_dma=xx the DMA
ncr_5380=1 to set up for a NCR5380 board
ncr_53c400=1 to set up for a NCR53C400 board
+ ncr_53c400a=1 to set up for a NCR53C400A board
+ dtc_3181e=1 to set up for a Domex Technology Corp 3181E board
+ hp_c2502=1 to set up for a Hewlett Packard C2502 board
e.g.
modprobe g_NCR5380 ncr_irq=5 ncr_addr=0x350 ncr_5380=1
for a port mapped NCR5380 board or