memory: brcmstb_dpfe: add separate entry for compile test
Add separate entry for Broadcom STB DPFE driver, enabled by default on
ARCH_BRCMSTB. This allows compile testing.
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Acked-by: Florian Fainelli <f.fainelli@gmail.com>
diff --git a/drivers/memory/Kconfig b/drivers/memory/Kconfig
index 2c79e95..7443280 100644
--- a/drivers/memory/Kconfig
+++ b/drivers/memory/Kconfig
@@ -52,6 +52,18 @@
tree is used. This bus supports NANDs, external ethernet controller,
SRAMs, ATA devices, etc.
+config BRCMSTB_DPFE
+ bool "Broadcom STB DPFE driver" if COMPILE_TEST
+ default y if ARCH_BRCMSTB
+ depends on ARCH_BRCMSTB || COMPILE_TEST
+ help
+ This driver provides access to the DPFE interface of Broadcom
+ STB SoCs. The firmware running on the DCPU inside the DDR PHY can
+ provide current information about the system's RAM, for instance
+ the DRAM refresh rate. This can be used as an indirect indicator
+ for the DRAM's temperature. Slower refresh rate means cooler RAM,
+ higher refresh rate means hotter RAM.
+
config BT1_L2_CTL
bool "Baikal-T1 CM2 L2-RAM Cache Control Block"
depends on MIPS_BAIKAL_T1 || COMPILE_TEST
diff --git a/drivers/memory/Makefile b/drivers/memory/Makefile
index b4533ff..e71cf7b 100644
--- a/drivers/memory/Makefile
+++ b/drivers/memory/Makefile
@@ -10,7 +10,7 @@
obj-$(CONFIG_ARM_PL172_MPMC) += pl172.o
obj-$(CONFIG_ATMEL_SDRAMC) += atmel-sdramc.o
obj-$(CONFIG_ATMEL_EBI) += atmel-ebi.o
-obj-$(CONFIG_ARCH_BRCMSTB) += brcmstb_dpfe.o
+obj-$(CONFIG_BRCMSTB_DPFE) += brcmstb_dpfe.o
obj-$(CONFIG_BT1_L2_CTL) += bt1-l2-ctl.o
obj-$(CONFIG_TI_AEMIF) += ti-aemif.o
obj-$(CONFIG_TI_EMIF) += emif.o