mmc: sdhci: execute tuning when device is not busy
We find tuning timeout because of the secure erase operation lasts too
long, so don't do tuning when device is busy.
Signed-off-by: Yi Sun <yi.y.sun@intel.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index db113ab..cbd4337 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -1366,11 +1366,12 @@
present_state = sdhci_readl(host, SDHCI_PRESENT_STATE);
/*
* Check if the re-tuning timer has already expired and there
- * is no on-going data transfer. If so, we need to execute
- * tuning procedure before sending command.
+ * is no on-going data transfer and DAT0 is not busy. If so,
+ * we need to execute tuning procedure before sending command.
*/
if ((host->flags & SDHCI_NEEDS_RETUNING) &&
- !(present_state & (SDHCI_DOING_WRITE | SDHCI_DOING_READ))) {
+ !(present_state & (SDHCI_DOING_WRITE | SDHCI_DOING_READ)) &&
+ (present_state & SDHCI_DATA_0_LVL_MASK)) {
if (mmc->card) {
/* eMMC uses cmd21 but sd and sdio use cmd19 */
tuning_opcode =