DS1WM: decouple host IRQ and INTR active state settings
The DS1WM driver incorrectly infers the IAS bit (1-wire interrupt active
high) from IRQ settings. There are devices that have IAS=0 but still need
the IRQ to trigger on a rising edge. With this patch, machines with DS1WM
that need IAS=1 have to set .active_high=1 in the ds1wm_platform_data.
Signed-off-by: Philipp Zabel <philipp.zabel@gmail.com>
Acked-by: Evgeniy Polyakov <johnpol@2ka.mipt.ru>
Acked-by: Matt Reimer <mreimer@vpop.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/w1/masters/ds1wm.c b/drivers/w1/masters/ds1wm.c
index 5747997..688e435 100644
--- a/drivers/w1/masters/ds1wm.c
+++ b/drivers/w1/masters/ds1wm.c
@@ -361,11 +361,12 @@
goto err1;
}
ds1wm_data->irq = res->start;
- ds1wm_data->active_high = (res->flags & IORESOURCE_IRQ_HIGHEDGE) ?
- 1 : 0;
+ ds1wm_data->active_high = plat->active_high;
- set_irq_type(ds1wm_data->irq, ds1wm_data->active_high ?
- IRQ_TYPE_EDGE_RISING : IRQ_TYPE_EDGE_FALLING);
+ if (res->flags & IORESOURCE_IRQ_HIGHEDGE)
+ set_irq_type(ds1wm_data->irq, IRQ_TYPE_EDGE_RISING);
+ if (res->flags & IORESOURCE_IRQ_LOWEDGE)
+ set_irq_type(ds1wm_data->irq, IRQ_TYPE_EDGE_FALLING);
ret = request_irq(ds1wm_data->irq, ds1wm_isr, IRQF_DISABLED,
"ds1wm", ds1wm_data);