Merge branch 'net-phy-call-phy_disable_interrupts-in-phy_init_hw'
Jisheng Zhang says:
====================
net: phy: call phy_disable_interrupts() in phy_init_hw()
We face an issue with rtl8211f, a pin is shared between INTB and PMEB,
and the PHY Register Accessible Interrupt is enabled by default, so
the INTB/PMEB pin is always active in polling mode case.
As Heiner pointed out "I was thinking about calling
phy_disable_interrupts() in phy_init_hw(), to have a defined init
state as we don't know in which state the PHY is if the PHY driver is
loaded. We shouldn't assume that it's the chip power-on defaults, BIOS
or boot loader could have changed this. Or in case of dual-boot
systems the other OS could leave the PHY in whatever state."
patch1 makes phy_disable_interrupts() non-static so that it could be used
in phy_init_hw() to have a defined init state.
patch2 calls phy_disable_interrupts() in phy_init_hw() to have a
defined init state.
Since v3:
- call phy_disable_interrupts() have interrupts disabled first then
config_init, thank Florian
Since v2:
- Don't export phy_disable_interrupts() but just make it non-static
Since v1:
- EXPORT the correct symbol
====================
Signed-off-by: David S. Miller <davem@davemloft.net>