mlx4_en: use NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM for tx csum at initialization
The former usage was to set the NETIF_F_HW_CSUM flag which is not used
in get_tx_csum. It caused Ethtool to show tx checksum as "on" even
though it was turned off in previous operation.
Signed-off-by: Yevgeny Petrilin <yevgenyp@mellanox.co.il>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/mlx4/en_netdev.c b/drivers/net/mlx4/en_netdev.c
index 09fb7cf..438678a 100644
--- a/drivers/net/mlx4/en_netdev.c
+++ b/drivers/net/mlx4/en_netdev.c
@@ -1057,7 +1057,7 @@
* Set driver features
*/
dev->features |= NETIF_F_SG;
- dev->features |= NETIF_F_HW_CSUM;
+ dev->features |= NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM;
dev->features |= NETIF_F_HIGHDMA;
dev->features |= NETIF_F_HW_VLAN_TX |
NETIF_F_HW_VLAN_RX |