Fix common misspellings
Fixes generated by 'codespell' and manually reviewed.
Signed-off-by: Lucas De Marchi <lucas.demarchi@profusion.mobi>
diff --git a/drivers/spi/amba-pl022.c b/drivers/spi/amba-pl022.c
index 5a4e0af..5825370 100644
--- a/drivers/spi/amba-pl022.c
+++ b/drivers/spi/amba-pl022.c
@@ -661,7 +661,7 @@
{
/*
- * The FIFO depth is different inbetween primecell variants.
+ * The FIFO depth is different between primecell variants.
* I believe filling in too much in the FIFO might cause
* errons in 8bit wide transfers on ARM variants (just 8 words
* FIFO, means only 8x8 = 64 bits in FIFO) at least.
@@ -722,7 +722,7 @@
* This inner reader takes care of things appearing in the RX
* FIFO as we're transmitting. This will happen a lot since the
* clock starts running when you put things into the TX FIFO,
- * and then things are continously clocked into the RX FIFO.
+ * and then things are continuously clocked into the RX FIFO.
*/
while ((readw(SSP_SR(pl022->virtbase)) & SSP_SR_MASK_RNE)
&& (pl022->rx < pl022->rx_end)) {
@@ -842,7 +842,7 @@
unmap_free_dma_scatter(pl022);
- /* Update total bytes transfered */
+ /* Update total bytes transferred */
msg->actual_length += pl022->cur_transfer->len;
if (pl022->cur_transfer->cs_change)
pl022->cur_chip->
@@ -1224,7 +1224,7 @@
"number of bytes on a 16bit bus?)\n",
(u32) (pl022->rx - pl022->rx_end));
}
- /* Update total bytes transfered */
+ /* Update total bytes transferred */
msg->actual_length += pl022->cur_transfer->len;
if (pl022->cur_transfer->cs_change)
pl022->cur_chip->
@@ -1415,11 +1415,11 @@
SSP_CR1(pl022->virtbase));
dev_dbg(&pl022->adev->dev, "polling transfer ongoing ...\n");
- /* FIXME: insert a timeout so we don't hang here indefinately */
+ /* FIXME: insert a timeout so we don't hang here indefinitely */
while (pl022->tx < pl022->tx_end || pl022->rx < pl022->rx_end)
readwriter(pl022);
- /* Update total byte transfered */
+ /* Update total byte transferred */
message->actual_length += pl022->cur_transfer->len;
if (pl022->cur_transfer->cs_change)
pl022->cur_chip->cs_control(SSP_CHIP_DESELECT);
@@ -2129,7 +2129,7 @@
"probe - problem registering spi master\n");
goto err_spi_register;
}
- dev_dbg(dev, "probe succeded\n");
+ dev_dbg(dev, "probe succeeded\n");
/*
* Disable the silicon block pclk and any voltage domain and just
* power it up and clock it when it's needed
@@ -2184,7 +2184,7 @@
spi_unregister_master(pl022->master);
spi_master_put(pl022->master);
amba_set_drvdata(adev, NULL);
- dev_dbg(&adev->dev, "remove succeded\n");
+ dev_dbg(&adev->dev, "remove succeeded\n");
return 0;
}