[SCSI] megaraid: fix sparse warnings
There's a zero day mistake in the megaraid driver in that the code that
obtains the version number does a >> 8 on a char quantity. This >>8 causes a
sparse warning because it always produces zero. Al Viro suggested these
shifts should be >> 4 thus treating the firmware version as a BCD quantity.
However, in the interests of safety we've elected to replace the >> 8
quantities with an explicit zero, thus quieting the sparse warning while
preserving the same (albeit incorrect) version number as had previously been
seen.
Signed-off-by: Adam Radford <aradford@gmail.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/megaraid.c b/drivers/scsi/megaraid.c
index 5c17764..15eefa1 100644
--- a/drivers/scsi/megaraid.c
+++ b/drivers/scsi/megaraid.c
@@ -306,19 +306,22 @@
adapter->host->sg_tablesize = adapter->sglen;
- /* use HP firmware and bios version encoding */
+ /* use HP firmware and bios version encoding
+ Note: fw_version[0|1] and bios_version[0|1] were originally shifted
+ right 8 bits making them zero. This 0 value was hardcoded to fix
+ sparse warnings. */
if (adapter->product_info.subsysvid == HP_SUBSYS_VID) {
sprintf (adapter->fw_version, "%c%d%d.%d%d",
adapter->product_info.fw_version[2],
- adapter->product_info.fw_version[1] >> 8,
+ 0,
adapter->product_info.fw_version[1] & 0x0f,
- adapter->product_info.fw_version[0] >> 8,
+ 0,
adapter->product_info.fw_version[0] & 0x0f);
sprintf (adapter->bios_version, "%c%d%d.%d%d",
adapter->product_info.bios_version[2],
- adapter->product_info.bios_version[1] >> 8,
+ 0,
adapter->product_info.bios_version[1] & 0x0f,
- adapter->product_info.bios_version[0] >> 8,
+ 0,
adapter->product_info.bios_version[0] & 0x0f);
} else {
memcpy(adapter->fw_version,