ARM: davinci: serial: get rid of davinci_uart_config
"struct davinci_uart_config" was introduced to specify
UART ports brought out or enabled on the board. But
none of the boards use it for that purpose and we are
not going to add anymore board files, so remove the
structure.
Signed-off-by: Manjunathappa, Prakash <prakash.pm@ti.com>
Suggested-by: Sekhar Nori <nsekhar@ti.com>
[nsekhar@ti.com: split patch to remove davinci_serial_setup_clk()
changes.]
Signed-off-by: Sekhar Nori <nsekhar@ti.com>
diff --git a/arch/arm/mach-davinci/board-omapl138-hawk.c b/arch/arm/mach-davinci/board-omapl138-hawk.c
index b8c20de..ab98c75 100644
--- a/arch/arm/mach-davinci/board-omapl138-hawk.c
+++ b/arch/arm/mach-davinci/board-omapl138-hawk.c
@@ -286,15 +286,11 @@
gpio_free(DA850_USB1_VBUS_PIN);
}
-static struct davinci_uart_config omapl138_hawk_uart_config __initdata = {
- .enabled_uarts = 0x7,
-};
-
static __init void omapl138_hawk_init(void)
{
int ret;
- davinci_serial_init(&omapl138_hawk_uart_config);
+ davinci_serial_init(da8xx_serial_device);
omapl138_hawk_config_emac();