i40e: Fix Rx checksum error counter
The Rx port checksum error counter was incrementing incorrectly with
UDP encapsulated tunneled traffic. This patch fixes the problem so that
the port_rx_csum counter will show accurate statistics.
Signed-off-by: Anjali Singhai <anjali.singhai@intel.com>
Signed-off-by: Greg Rose <gregory.v.rose@intel.com>
Tested-by: Jim Young <james.m.young@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/i40e/i40e_txrx.c b/drivers/net/ethernet/intel/i40e/i40e_txrx.c
index f145aaf..38c7638 100644
--- a/drivers/net/ethernet/intel/i40e/i40e_txrx.c
+++ b/drivers/net/ethernet/intel/i40e/i40e_txrx.c
@@ -1325,9 +1325,7 @@
* so the total length of IPv4 header is IHL*4 bytes
* The UDP_0 bit *may* bet set if the *inner* header is UDP
*/
- if (ipv4_tunnel &&
- (decoded.inner_prot != I40E_RX_PTYPE_INNER_PROT_UDP) &&
- !(rx_status & (1 << I40E_RX_DESC_STATUS_UDP_0_SHIFT))) {
+ if (ipv4_tunnel) {
skb->transport_header = skb->mac_header +
sizeof(struct ethhdr) +
(ip_hdr(skb)->ihl * 4);
@@ -1337,15 +1335,19 @@
skb->protocol == htons(ETH_P_8021AD))
? VLAN_HLEN : 0;
- rx_udp_csum = udp_csum(skb);
- iph = ip_hdr(skb);
- csum = csum_tcpudp_magic(
- iph->saddr, iph->daddr,
- (skb->len - skb_transport_offset(skb)),
- IPPROTO_UDP, rx_udp_csum);
+ if ((ip_hdr(skb)->protocol == IPPROTO_UDP) &&
+ (udp_hdr(skb)->check != 0)) {
+ rx_udp_csum = udp_csum(skb);
+ iph = ip_hdr(skb);
+ csum = csum_tcpudp_magic(
+ iph->saddr, iph->daddr,
+ (skb->len - skb_transport_offset(skb)),
+ IPPROTO_UDP, rx_udp_csum);
- if (udp_hdr(skb)->check != csum)
- goto checksum_fail;
+ if (udp_hdr(skb)->check != csum)
+ goto checksum_fail;
+
+ } /* else its GRE and so no outer UDP header */
}
skb->ip_summed = CHECKSUM_UNNECESSARY;