[SCSI] qla4xxx: Trivial cleanup
* cleanup function qla4xxx_recovery_timeout
- No need to wakeup dpc thread from function
qla4xxx_recovery_timeout() as we are not doing anything
in do_dpc() thread when wakeup from
qla4xxx_recovery_timeout()
* cleanup function qla4xxx_wait_for_hba_online
- Remove hard coded value from qla4xxx_wait_for_hba_online().
* cleanup function qla4xxx_start_firmware_from_flash
- display seconds
* cleanup function qla4_8xxx_load_risc
- Remove redundant code.
* cleanup function qla4xxx_get_firmware_status
- update debug statement
* cleanup function qla4_8xxx_try_start_fw
- update return status
Signed-off-by: Vikas Chaudhary <vikas.chaudhary@qlogic.com>
Signed-off-by: Ravi Anand <ravi.anand@qlogic.com>
Reviewed-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>
diff --git a/drivers/scsi/qla4xxx/ql4_nx.c b/drivers/scsi/qla4xxx/ql4_nx.c
index 449256f..b311a96 100644
--- a/drivers/scsi/qla4xxx/ql4_nx.c
+++ b/drivers/scsi/qla4xxx/ql4_nx.c
@@ -1540,10 +1540,12 @@
ql4_printk(KERN_INFO, ha,
"FW: Attempting to load firmware from flash...\n");
rval = qla4_8xxx_start_firmware(ha, ha->hw.flt_region_fw);
- if (rval == QLA_SUCCESS)
- return rval;
- ql4_printk(KERN_ERR, ha, "FW: Load firmware from flash FAILED...\n");
+ if (rval != QLA_SUCCESS) {
+ ql4_printk(KERN_ERR, ha, "FW: Load firmware from flash"
+ " FAILED...\n");
+ return rval;
+ }
return rval;
}
@@ -1764,20 +1766,9 @@
int retval;
retval = qla4_8xxx_device_state_handler(ha);
- if (retval == QLA_SUCCESS &&
- !test_bit(AF_INIT_DONE, &ha->flags)) {
+ if (retval == QLA_SUCCESS && !test_bit(AF_INIT_DONE, &ha->flags))
retval = qla4xxx_request_irqs(ha);
- if (retval != QLA_SUCCESS) {
- ql4_printk(KERN_WARNING, ha,
- "Failed to reserve interrupt %d already in use.\n",
- ha->pdev->irq);
- } else {
- set_bit(AF_IRQ_ATTACHED, &ha->flags);
- ha->host->irq = ha->pdev->irq;
- ql4_printk(KERN_INFO, ha, "%s: irq %d attached\n",
- __func__, ha->pdev->irq);
- }
- }
+
return retval;
}