ath9k: Setup short preamble properly in rate registration
This patch fixes an issue where hw_value_short was not being filled
with the proper ratecode during rate registration, but was being used
in the RX path for decoding the packet rate.
Signed-off-by: Sujith <Sujith.Manoharan@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath9k/main.c b/drivers/net/wireless/ath9k/main.c
index e9b0684..d8e8266 100644
--- a/drivers/net/wireless/ath9k/main.c
+++ b/drivers/net/wireless/ath9k/main.c
@@ -217,7 +217,13 @@
for (i = 0; i < maxrates; i++) {
rate[i].bitrate = rate_table->info[i].ratekbps / 100;
rate[i].hw_value = rate_table->info[i].ratecode;
+ if (rate_table->info[i].short_preamble) {
+ rate[i].hw_value_short = rate_table->info[i].ratecode |
+ rate_table->info[i].short_preamble;
+ rate[i].flags = IEEE80211_RATE_SHORT_PREAMBLE;
+ }
sband->n_bitrates++;
+
DPRINTF(sc, ATH_DBG_CONFIG, "Rate: %2dMbps, ratecode: %2d\n",
rate[i].bitrate / 10, rate[i].hw_value);
}