i2c: core: Allow drivers to disable i2c-core irq mapping
By default the i2c-core will try to get an irq with index 0 on ACPI / of
instantiated devices. This is troublesome on some ACPI systems where the
irq info at index 0 in the CRS table may contain nonsense and/or point
to an irqchip for which there is no Linux driver.
If this happens then before this commit the driver's probe method would
never get called because i2c_device_probe will try to get an irq by
calling acpi_dev_gpio_irq_get which will always return -EPROBE in this
case, as it waits for a matching irqchip driver to load. Thus causing
the driver to not get a chance to bind.
This commit adds a new disable_i2c_core_irq_mapping flag to struct
i2c_driver which a driver can set to tell the core to skip irq mapping.
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/include/linux/i2c.h b/include/linux/i2c.h
index 53fa50f..3a57e3d 100644
--- a/include/linux/i2c.h
+++ b/include/linux/i2c.h
@@ -149,6 +149,7 @@ enum i2c_alert_protocol {
* @detect: Callback for device detection
* @address_list: The I2C addresses to probe (for detect)
* @clients: List of detected clients we created (for i2c-core use only)
+ * @disable_i2c_core_irq_mapping: Tell the i2c-core to not do irq-mapping
*
* The driver.owner field should be set to the module owner of this driver.
* The driver.name field should be set to the name of this driver.
@@ -212,6 +213,8 @@ struct i2c_driver {
int (*detect)(struct i2c_client *, struct i2c_board_info *);
const unsigned short *address_list;
struct list_head clients;
+
+ bool disable_i2c_core_irq_mapping;
};
#define to_i2c_driver(d) container_of(d, struct i2c_driver, driver)