IB/ipath: Remove support for preproduction HTX InfiniPath cards
Clean up some code by removing support for some older pre-production
HTX InfiniPath cards.
Signed-off-by: Ralph Campbell <ralph.campbell@qlogic.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_iba6110.c b/drivers/infiniband/hw/ipath/ipath_iba6110.c
index fdfa95d..650745d 100644
--- a/drivers/infiniband/hw/ipath/ipath_iba6110.c
+++ b/drivers/infiniband/hw/ipath/ipath_iba6110.c
@@ -677,6 +677,12 @@
if (n)
snprintf(name, namelen, "%s", n);
+ if (dd->ipath_boardrev != 6 && dd->ipath_boardrev != 7 &&
+ dd->ipath_boardrev != 11) {
+ ipath_dev_err(dd, "Unsupported InfiniPath board %s!\n", name);
+ ret = 1;
+ goto bail;
+ }
if (dd->ipath_majrev != 3 || (dd->ipath_minrev < 2 ||
dd->ipath_minrev > 4)) {
/*
@@ -694,36 +700,11 @@
* copies
*/
dd->ipath_flags |= IPATH_32BITCOUNTERS;
+ dd->ipath_flags |= IPATH_GPIO_INTR;
if (dd->ipath_htspeed != 800)
ipath_dev_err(dd,
"Incorrectly configured for HT @ %uMHz\n",
dd->ipath_htspeed);
- if (dd->ipath_boardrev == 7 || dd->ipath_boardrev == 11 ||
- dd->ipath_boardrev == 6)
- dd->ipath_flags |= IPATH_GPIO_INTR;
- else
- dd->ipath_flags |= IPATH_POLL_RX_INTR;
- if (dd->ipath_boardrev == 8) { /* LS/X-1 */
- u64 val;
- val = ipath_read_kreg64(dd, dd->ipath_kregs->kr_extstatus);
- if (val & INFINIPATH_EXTS_SERDESSEL) {
- /*
- * hardware disabled
- *
- * This means that the chip is hardware disabled,
- * and will not be able to bring up the link,
- * in any case. We special case this and abort
- * early, to avoid later messages. We also set
- * the DISABLED status bit
- */
- ipath_dbg("Unit %u is hardware-disabled\n",
- dd->ipath_unit);
- *dd->ipath_statusp |= IPATH_STATUS_DISABLED;
- /* this value is handled differently */
- ret = 2;
- goto bail;
- }
- }
ret = 0;
bail:
@@ -1574,8 +1555,10 @@
* with 128, rather than 112.
*/
dd->ipath_flags |= IPATH_GPIO_INTR;
- dd->ipath_flags &= ~IPATH_POLL_RX_INTR;
- }
+ } else
+ ipath_dev_err(dd, "Unsupported InfiniPath serial "
+ "number %.16s!\n", dd->ipath_serial);
+
return 0;
}