synclink_gt: leave transmitter in reset state after configuration
Leave the transmitter in reset state after configuration so that transmit
signal is held at mark until transmitter is explicitly enabled by
application, otherwise transmitter sends idle pattern.
Signed-off-by: Paul Fulghum <paulkf@microgate.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Alan Cox <alan@lxorguk.ukuu.org.uk>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/char/synclink_gt.c b/drivers/char/synclink_gt.c
index 8511e2e..c8bc69c 100644
--- a/drivers/char/synclink_gt.c
+++ b/drivers/char/synclink_gt.c
@@ -4134,7 +4134,7 @@
* 01 enable
* 00 auto-CTS enable
*/
- val = 0;
+ val = BIT2;
switch(info->params.mode) {
case MGSL_MODE_MONOSYNC: val |= BIT14 + BIT13; break;