RDMA/cxgb3: Fix the T3A workaround checks
Correctly work around T3A issues by checking "hwtype != T3A" instead of
"hwtype == T3B". This will be needed for new hardware types.
Signed-off-by: Steve Wise <swise@opengridcomputing.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/cxgb3/iwch_cm.c b/drivers/infiniband/hw/cxgb3/iwch_cm.c
index 20ba372..f8cb0fe 100644
--- a/drivers/infiniband/hw/cxgb3/iwch_cm.c
+++ b/drivers/infiniband/hw/cxgb3/iwch_cm.c
@@ -1118,7 +1118,7 @@
status2errno(rpl->status));
connect_reply_upcall(ep, status2errno(rpl->status));
state_set(&ep->com, DEAD);
- if (ep->com.tdev->type == T3B && act_open_has_tid(rpl->status))
+ if (ep->com.tdev->type != T3A && act_open_has_tid(rpl->status))
release_tid(ep->com.tdev, GET_TID(rpl), NULL);
cxgb3_free_atid(ep->com.tdev, ep->atid);
dst_release(ep->dst);
@@ -1249,7 +1249,7 @@
skb_trim(skb, sizeof(struct cpl_tid_release));
skb_get(skb);
- if (tdev->type == T3B)
+ if (tdev->type != T3A)
release_tid(tdev, hwtid, skb);
else {
struct cpl_pass_accept_rpl *rpl;