[POWERPC] QE: change qe_setbrg() to take an enum qe_clock instead of an integer
qe_setbrg() currently takes an integer to indicate the BRG number. Change that
to take an enum qe_clock instead, since this enum is intended to represent
clock sources.
Signed-off-by: Timur Tabi <timur@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/sysdev/qe_lib/qe.c b/arch/powerpc/sysdev/qe_lib/qe.c
index 3d57d38..1df3b4a 100644
--- a/arch/powerpc/sysdev/qe_lib/qe.c
+++ b/arch/powerpc/sysdev/qe_lib/qe.c
@@ -167,19 +167,20 @@
/* Program the BRG to the given sampling rate and multiplier
*
- * @brg: the BRG, 1-16
+ * @brg: the BRG, QE_BRG1 - QE_BRG16
* @rate: the desired sampling rate
* @multiplier: corresponds to the value programmed in GUMR_L[RDCR] or
* GUMR_L[TDCR]. E.g., if this BRG is the RX clock, and GUMR_L[RDCR]=01,
* then 'multiplier' should be 8.
- *
- * Also note that the value programmed into the BRGC register must be even.
*/
-void qe_setbrg(unsigned int brg, unsigned int rate, unsigned int multiplier)
+int qe_setbrg(enum qe_clock brg, unsigned int rate, unsigned int multiplier)
{
u32 divisor, tempval;
u32 div16 = 0;
+ if ((brg < QE_BRG1) || (brg > QE_BRG16))
+ return -EINVAL;
+
divisor = get_brg_clk() / (rate * multiplier);
if (divisor > QE_BRGC_DIVISOR_MAX + 1) {
@@ -196,8 +197,11 @@
tempval = ((divisor - 1) << QE_BRGC_DIVISOR_SHIFT) |
QE_BRGC_ENABLE | div16;
- out_be32(&qe_immr->brg.brgc[brg - 1], tempval);
+ out_be32(&qe_immr->brg.brgc[brg - QE_BRG1], tempval);
+
+ return 0;
}
+EXPORT_SYMBOL(qe_setbrg);
/* Initialize SNUMs (thread serial numbers) according to
* QE Module Control chapter, SNUM table