cfg80211: 802.11p OCB mode handling
This patch adds new iface type (NL80211_IFTYPE_OCB) representing
the OCB (Outside the Context of a BSS) mode.
When establishing a connection to the network a cfg80211_join_ocb
function is called (particular nl80211_command is added as well).
A mandatory parameters during the ocb_join operation are 'center
frequency' and 'channel width (5/10 MHz)'.
Changes done in mac80211 are minimal possible required to avoid
many warnings (warning: enumeration value 'NL80211_IFTYPE_OCB'
not handled in switch) during compilation. Full functionality
(where needed) is added in the following patch.
Signed-off-by: Rostislav Lisovy <rostislav.lisovy@fel.cvut.cz>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/wireless/trace.h b/net/wireless/trace.h
index cdb2c2e..277a85d 100644
--- a/net/wireless/trace.h
+++ b/net/wireless/trace.h
@@ -600,6 +600,11 @@
TP_ARGS(wiphy, netdev)
);
+DEFINE_EVENT(wiphy_netdev_evt, rdev_leave_ocb,
+ TP_PROTO(struct wiphy *wiphy, struct net_device *netdev),
+ TP_ARGS(wiphy, netdev)
+);
+
DEFINE_EVENT(wiphy_netdev_evt, rdev_flush_pmksa,
TP_PROTO(struct wiphy *wiphy, struct net_device *netdev),
TP_ARGS(wiphy, netdev)
@@ -1316,6 +1321,22 @@
WIPHY_PR_ARG, NETDEV_PR_ARG, MAC_PR_ARG(bssid), __entry->ssid)
);
+TRACE_EVENT(rdev_join_ocb,
+ TP_PROTO(struct wiphy *wiphy, struct net_device *netdev,
+ const struct ocb_setup *setup),
+ TP_ARGS(wiphy, netdev, setup),
+ TP_STRUCT__entry(
+ WIPHY_ENTRY
+ NETDEV_ENTRY
+ ),
+ TP_fast_assign(
+ WIPHY_ASSIGN;
+ NETDEV_ASSIGN;
+ ),
+ TP_printk(WIPHY_PR_FMT ", " NETDEV_PR_FMT,
+ WIPHY_PR_ARG, NETDEV_PR_ARG)
+);
+
TRACE_EVENT(rdev_set_wiphy_params,
TP_PROTO(struct wiphy *wiphy, u32 changed),
TP_ARGS(wiphy, changed),