ath5k: configure backoff for IBSS beacon queue
in "11.1.2.2 Beacon generation in an IBSS" the IEEE802.11 standard says, each
STA should... "b) Calculate a random delay uniformly distributed in the range
between zero and twice aCWmin × aSlotTime,".
configure cwmin and cwmax of the beacon queue in IBSS mode according to this.
unfortunately beacon backoff does not work reliably yet, so i suspect we have a
problem somewhere else, since the same settings (and similar beacon timer
configuration) work for madwifi.
drivers/net/wireless/ath5k/base.c: Changes-licensed-under: 3-Clause-BSD
Signed-off-by: Bruno Randolf <bruno@thinktube.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath5k/base.c b/drivers/net/wireless/ath5k/base.c
index eb98284..b2a6ef5 100644
--- a/drivers/net/wireless/ath5k/base.c
+++ b/drivers/net/wireless/ath5k/base.c
@@ -1458,8 +1458,7 @@
ret = ath5k_hw_get_tx_queueprops(ah, sc->bhalq, &qi);
if (ret)
return ret;
- if (sc->opmode == IEEE80211_IF_TYPE_AP ||
- sc->opmode == IEEE80211_IF_TYPE_IBSS) {
+ if (sc->opmode == IEEE80211_IF_TYPE_AP) {
/*
* Always burst out beacon and CAB traffic
* (aifs = cwmin = cwmax = 0)
@@ -1467,8 +1466,19 @@
qi.tqi_aifs = 0;
qi.tqi_cw_min = 0;
qi.tqi_cw_max = 0;
+ } else if (sc->opmode == IEEE80211_IF_TYPE_IBSS) {
+ /*
+ * Adhoc mode; backoff between 0 and (2 * cw_min).
+ */
+ qi.tqi_aifs = 0;
+ qi.tqi_cw_min = 0;
+ qi.tqi_cw_max = 2 * ah->ah_cw_min;
}
+ ATH5K_DBG(sc, ATH5K_DEBUG_BEACON,
+ "beacon queueprops tqi_aifs:%d tqi_cw_min:%d tqi_cw_max:%d\n",
+ qi.tqi_aifs, qi.tqi_cw_min, qi.tqi_cw_max);
+
ret = ath5k_hw_setup_tx_queueprops(ah, sc->bhalq, &qi);
if (ret) {
ATH5K_ERR(sc, "%s: unable to update parameters for beacon "