[PATCH] S2io: Hardware fixes
Hi,
Below patch addresses few h/w specific issues.
1. Check for additional ownership bit on Rx path before
starting Rx processing.
2. Enable only 4 PCCs(Per Context Controller) for Xframe I
revisions less than 4.
3. Program Rx and Tx round robin registers depending on
no. of rings/FIFOs.
4. Tx continous interrupts is now a loadable parameter.
5. Reset the card if we get double-bit ECC errors.
6. A soft reset of XGXS being done to force a link state change has been
eliminated.
7. After a reset, clear "parity error detected" bit,
PCI-X ECC status register, and PCI_STATUS bit in
tx_pic_int register.
8. The error in the disabling allmulticast implementation has been
rectified.
9. Leave the PCI-X parameters MMRBC, OST etc. at their
BIOS/system defaults.
Signed-off-by: Ravinandan Arakali <ravinandan.arakali@neterion.com>
Signed-off-by: Raghavendra Koushik <raghavendra.koushik@neterion.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
diff --git a/drivers/net/s2io-regs.h b/drivers/net/s2io-regs.h
index 8746740..826deb0 100644
--- a/drivers/net/s2io-regs.h
+++ b/drivers/net/s2io-regs.h
@@ -62,6 +62,7 @@
#define ADAPTER_STATUS_RMAC_REMOTE_FAULT BIT(6)
#define ADAPTER_STATUS_RMAC_LOCAL_FAULT BIT(7)
#define ADAPTER_STATUS_RMAC_PCC_IDLE vBIT(0xFF,8,8)
+#define ADAPTER_STATUS_RMAC_PCC_FOUR_IDLE vBIT(0x0F,8,8)
#define ADAPTER_STATUS_RC_PRC_QUIESCENT vBIT(0xFF,16,8)
#define ADAPTER_STATUS_MC_DRAM_READY BIT(24)
#define ADAPTER_STATUS_MC_QUEUES_READY BIT(25)
@@ -245,6 +246,7 @@
#define STAT_TRSF_PER(n) TBD
#define PER_SEC 0x208d5
#define SET_UPDT_PERIOD(n) vBIT((PER_SEC*n),32,32)
+#define SET_UPDT_CLICKS(val) vBIT(val, 32, 32)
u64 stat_addr;
@@ -289,6 +291,7 @@
u64 pcc_err_reg;
#define PCC_FB_ECC_DB_ERR vBIT(0xFF, 16, 8)
+#define PCC_ENABLE_FOUR vBIT(0x0F,0,8)
u64 pcc_err_mask;
u64 pcc_err_alarm;
@@ -690,6 +693,10 @@
#define MC_ERR_REG_MIRI_CRI_ERR_0 BIT(22)
#define MC_ERR_REG_MIRI_CRI_ERR_1 BIT(23)
#define MC_ERR_REG_SM_ERR BIT(31)
+#define MC_ERR_REG_ECC_ALL_SNG (BIT(6) | \
+ BIT(7) | BIT(17) | BIT(19))
+#define MC_ERR_REG_ECC_ALL_DBL (BIT(14) | \
+ BIT(15) | BIT(18) | BIT(20))
u64 mc_err_mask;
u64 mc_err_alarm;