ntb_hw_switchtec: Allow using Switchtec NTB in multi-partition setups
Allow using Switchtec NTB in setups that have more than two partitions.
Note: this does not enable having multi-host communication, it only
allows for a single NTB link between two hosts in a network that might
have more than two.
Use following logic to determine the NT peer partition:
1) If there are 2 partitions, and the target vector is set in
the Switchtec configuration, use the partition specified in target
vector.
2) If there are 2 partitions and target vector is unset
use the only other partition as specified in the NT EP map.
3) If there are more than 2 partitions and target vector is set
use the other partition specified in target vector.
4) If there are more than 2 partitions and target vector is unset,
this is invalid and report an error.
Signed-off-by: Kelvin Cao <kelvin.cao@microsemi.com>
[logang@deltatee.com: commit message fleshed out]
Signed-off-by: Logan Gunthorpe <logang@deltatee.com>
Reviewed-by: Logan Gunthorpe <logang@deltatee.com>
Signed-off-by: Jon Mason <jdmason@kudzu.us>
diff --git a/include/linux/switchtec.h b/include/linux/switchtec.h
index 09d73d0d..d4a7c18 100644
--- a/include/linux/switchtec.h
+++ b/include/linux/switchtec.h
@@ -168,6 +168,14 @@ struct ntb_info_regs {
u16 reserved1;
u64 ep_map;
u16 requester_id;
+ u16 reserved2;
+ u32 reserved3[4];
+ struct nt_partition_info {
+ u32 xlink_enabled;
+ u32 target_part_low;
+ u32 target_part_high;
+ u32 reserved;
+ } ntp_info[48];
} __packed;
struct part_cfg_regs {