Documentation: bareudp: update iproute2 sample commands
bareudp.rst was written before iproute2 gained support for this new
type of tunnel. Therefore, the sample command lines didn't match the
final iproute2 implementation.
Signed-off-by: Guillaume Nault <gnault@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/Documentation/networking/bareudp.rst b/Documentation/networking/bareudp.rst
index 465a8b2..ff40656 100644
--- a/Documentation/networking/bareudp.rst
+++ b/Documentation/networking/bareudp.rst
@@ -26,7 +26,7 @@
1) Device creation & deletion
- a) ip link add dev bareudp0 type bareudp dstport 6635 ethertype 0x8847.
+ a) ip link add dev bareudp0 type bareudp dstport 6635 ethertype mpls_uc
This creates a bareudp tunnel device which tunnels L3 traffic with ethertype
0x8847 (MPLS traffic). The destination port of the UDP header will be set to
@@ -34,14 +34,21 @@
b) ip link delete bareudp0
-2) Device creation with multiple proto mode enabled
+2) Device creation with multiproto mode enabled
-There are two ways to create a bareudp device for MPLS & IP with multiproto mode
-enabled.
+The multiproto mode allows bareudp tunnels to handle several protocols of the
+same family. It is currently only available for IP and MPLS. This mode has to
+be enabled explicitly with the "multiproto" flag.
- a) ip link add dev bareudp0 type bareudp dstport 6635 ethertype 0x8847 multiproto
+ a) ip link add dev bareudp0 type bareudp dstport 6635 ethertype ipv4 multiproto
- b) ip link add dev bareudp0 type bareudp dstport 6635 ethertype mpls
+ For an IPv4 tunnel the multiproto mode allows the tunnel to also handle
+ IPv6.
+
+ b) ip link add dev bareudp0 type bareudp dstport 6635 ethertype mpls_uc multiproto
+
+ For MPLS, the multiproto mode allows the tunnel to handle both unicast
+ and multicast MPLS packets.
3) Device Usage