firmware: qcom-scm: build for correct architecture level
The ".arch_extension sec" directive is only available on ARMv6 or higher,
so if we enable the SCM driver while building a kernel for an older CPU,
we get a build error:
/tmp/ccUyhMOY.s:130: Error: selected processor does not support ARM mode `smc #0'
/tmp/ccUyhMOY.s:216: Error: selected processor does not support ARM mode `smc #0'
/tmp/ccUyhMOY.s:373: Error: selected processor does not support ARM mode `smc #0'
make[4]: *** [drivers/firmware/qcom_scm-32.o] Error 1
This changes the Makefile so we pass the ARMv7 architecture level both
for the check and for the actual compilation of the scm driver.
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Andy Gross <agross@codeaurora.org>
diff --git a/drivers/firmware/Makefile b/drivers/firmware/Makefile
index 2ee8347..f006637 100644
--- a/drivers/firmware/Makefile
+++ b/drivers/firmware/Makefile
@@ -15,7 +15,7 @@
obj-$(CONFIG_QCOM_SCM) += qcom_scm.o
obj-$(CONFIG_QCOM_SCM_64) += qcom_scm-64.o
obj-$(CONFIG_QCOM_SCM_32) += qcom_scm-32.o
-CFLAGS_qcom_scm-32.o :=$(call as-instr,.arch_extension sec,-DREQUIRES_SEC=1)
+CFLAGS_qcom_scm-32.o :=$(call as-instr,.arch armv7-a\n.arch_extension sec,-DREQUIRES_SEC=1) -march=armv7-a
obj-y += broadcom/
obj-$(CONFIG_GOOGLE_FIRMWARE) += google/