docs: networking: convert ipv6.txt to ReST
Not much to be done here:
- add SPDX header;
- add a document title;
- mark a literal as such, in order to avoid a warning;
- add to networking/index.rst.
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/Documentation/admin-guide/kernel-parameters.txt b/Documentation/admin-guide/kernel-parameters.txt
index e37db6f..e43f2e1 100644
--- a/Documentation/admin-guide/kernel-parameters.txt
+++ b/Documentation/admin-guide/kernel-parameters.txt
@@ -356,7 +356,7 @@
shot down by NMI
autoconf= [IPV6]
- See Documentation/networking/ipv6.txt.
+ See Documentation/networking/ipv6.rst.
show_lapic= [APIC,X86] Advanced Programmable Interrupt Controller
Limit apic dumping. The parameter defines the maximal
@@ -872,7 +872,7 @@
miss to occur.
disable= [IPV6]
- See Documentation/networking/ipv6.txt.
+ See Documentation/networking/ipv6.rst.
hardened_usercopy=
[KNL] Under CONFIG_HARDENED_USERCOPY, whether
@@ -912,7 +912,7 @@
to workaround buggy firmware.
disable_ipv6= [IPV6]
- See Documentation/networking/ipv6.txt.
+ See Documentation/networking/ipv6.rst.
disable_mtrr_cleanup [X86]
The kernel tries to adjust MTRR layout from continuous
diff --git a/Documentation/networking/index.rst b/Documentation/networking/index.rst
index 7d133d8..7096754 100644
--- a/Documentation/networking/index.rst
+++ b/Documentation/networking/index.rst
@@ -70,6 +70,7 @@
iphase
ipsec
ip-sysctl
+ ipv6
.. only:: subproject and html
diff --git a/Documentation/networking/ipv6.txt b/Documentation/networking/ipv6.rst
similarity index 92%
rename from Documentation/networking/ipv6.txt
rename to Documentation/networking/ipv6.rst
index 6cd74fa..ba09c2f 100644
--- a/Documentation/networking/ipv6.txt
+++ b/Documentation/networking/ipv6.rst
@@ -1,9 +1,15 @@
+.. SPDX-License-Identifier: GPL-2.0
+
+====
+IPv6
+====
+
Options for the ipv6 module are supplied as parameters at load time.
Module options may be given as command line arguments to the insmod
or modprobe command, but are usually specified in either
-/etc/modules.d/*.conf configuration files, or in a distro-specific
+``/etc/modules.d/*.conf`` configuration files, or in a distro-specific
configuration file.
The available ipv6 module parameters are listed below. If a parameter
diff --git a/net/ipv6/Kconfig b/net/ipv6/Kconfig
index 2ccaee9..5a6111d 100644
--- a/net/ipv6/Kconfig
+++ b/net/ipv6/Kconfig
@@ -13,7 +13,7 @@
For general information about IPv6, see
<https://en.wikipedia.org/wiki/IPv6>.
For specific information about IPv6 under Linux, see
- Documentation/networking/ipv6.txt and read the HOWTO at
+ Documentation/networking/ipv6.rst and read the HOWTO at
<http://www.tldp.org/HOWTO/Linux+IPv6-HOWTO/>
To compile this protocol support as a module, choose M here: the