hwmon: (ltc4215) make sysfs file match the alarm cause
The ltc4215 driver used the chip's "power good" status bit to provide
the power1_alarm file. This is wrong: the chip is really reporting the
status of one of the monitored voltages.
Change the sysfs file from power1_alarm to in2_min_alarm instead. This
matches the voltage that the chip is raising an alarm for.
Signed-off-by: Ira W. Snyder <iws@ovro.caltech.edu>
Signed-off-by: Guenter Roeck <guenter.roeck@ericsson.com>
diff --git a/drivers/hwmon/ltc4215.c b/drivers/hwmon/ltc4215.c
index 00d975e..c7e6d8e 100644
--- a/drivers/hwmon/ltc4215.c
+++ b/drivers/hwmon/ltc4215.c
@@ -205,7 +205,6 @@
/* Power (virtual) */
LTC4215_POWER(power1_input);
-LTC4215_ALARM(power1_alarm, (1 << 3), LTC4215_STATUS);
/* Input Voltage */
LTC4215_VOLTAGE(in1_input, LTC4215_ADIN);
@@ -214,6 +213,7 @@
/* Output Voltage */
LTC4215_VOLTAGE(in2_input, LTC4215_SOURCE);
+LTC4215_ALARM(in2_min_alarm, (1 << 3), LTC4215_STATUS);
/* Finally, construct an array of pointers to members of the above objects,
* as required for sysfs_create_group()
@@ -223,13 +223,13 @@
&sensor_dev_attr_curr1_max_alarm.dev_attr.attr,
&sensor_dev_attr_power1_input.dev_attr.attr,
- &sensor_dev_attr_power1_alarm.dev_attr.attr,
&sensor_dev_attr_in1_input.dev_attr.attr,
&sensor_dev_attr_in1_max_alarm.dev_attr.attr,
&sensor_dev_attr_in1_min_alarm.dev_attr.attr,
&sensor_dev_attr_in2_input.dev_attr.attr,
+ &sensor_dev_attr_in2_min_alarm.dev_attr.attr,
NULL,
};