MIPS: MSP71xx: Resolve use of non-existent GPIO routines in msp71xx reset
There have been a number of compile problems with the msp71xx configuration
ever since it was included in the linux-mips.org repository. This patch
resolves compilation problems with attempting to reset the board using
non-existent GPIO routines.
This patch has been compile-tested against the current HEAD.
Signed-off-by: Shane McDonald <mcdonald.shane@gmail.com>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
diff --git a/arch/mips/pmc-sierra/msp71xx/msp_setup.c b/arch/mips/pmc-sierra/msp71xx/msp_setup.c
index c936756..a54e85b 100644
--- a/arch/mips/pmc-sierra/msp71xx/msp_setup.c
+++ b/arch/mips/pmc-sierra/msp71xx/msp_setup.c
@@ -21,7 +21,6 @@
#if defined(CONFIG_PMC_MSP7120_GW)
#include <msp_regops.h>
-#include <msp_gpio.h>
#define MSP_BOARD_RESET_GPIO 9
#endif
@@ -88,11 +87,8 @@
* as GPIO char driver may not be enabled and it would look up
* data inRAM!
*/
- set_value_reg32(GPIO_CFG3_REG,
- basic_mode_mask(MSP_BOARD_RESET_GPIO),
- basic_mode(MSP_GPIO_OUTPUT, MSP_BOARD_RESET_GPIO));
- set_reg32(GPIO_DATA3_REG,
- basic_data_mask(MSP_BOARD_RESET_GPIO));
+ set_value_reg32(GPIO_CFG3_REG, 0xf000, 0x8000);
+ set_reg32(GPIO_DATA3_REG, 8);
/*
* In case GPIO9 doesn't reset the board (jumper configurable!)