mv643xx_eth: use longer DMA bursts
The mv643xx_eth driver is limiting DMA bursts to 32 bytes, while
using the largest burst size (128 bytes) gives a couple percentage
points performance improvement in throughput tests, and the docs
say that the 128 byte default should not need to be changed, so
use 128 byte bursts instead.
Signed-off-by: Lennert Buytenhek <buytenh@marvell.com>
diff --git a/drivers/net/mv643xx_eth.c b/drivers/net/mv643xx_eth.c
index c700c1f..9d20056 100644
--- a/drivers/net/mv643xx_eth.c
+++ b/drivers/net/mv643xx_eth.c
@@ -129,21 +129,21 @@
/*
* SDMA configuration register.
*/
-#define RX_BURST_SIZE_4_64BIT (2 << 1)
+#define RX_BURST_SIZE_16_64BIT (4 << 1)
#define BLM_RX_NO_SWAP (1 << 4)
#define BLM_TX_NO_SWAP (1 << 5)
-#define TX_BURST_SIZE_4_64BIT (2 << 22)
+#define TX_BURST_SIZE_16_64BIT (4 << 22)
#if defined(__BIG_ENDIAN)
#define PORT_SDMA_CONFIG_DEFAULT_VALUE \
- RX_BURST_SIZE_4_64BIT | \
- TX_BURST_SIZE_4_64BIT
+ RX_BURST_SIZE_16_64BIT | \
+ TX_BURST_SIZE_16_64BIT
#elif defined(__LITTLE_ENDIAN)
#define PORT_SDMA_CONFIG_DEFAULT_VALUE \
- RX_BURST_SIZE_4_64BIT | \
+ RX_BURST_SIZE_16_64BIT | \
BLM_RX_NO_SWAP | \
BLM_TX_NO_SWAP | \
- TX_BURST_SIZE_4_64BIT
+ TX_BURST_SIZE_16_64BIT
#else
#error One of __BIG_ENDIAN or __LITTLE_ENDIAN must be defined
#endif