firewire: ohci: Turn remote DMA support into a module parameter
This makes it possible to debug kernel over FireWire without the need to
recompile it.
[Stefan R: changed description from "...0" to "...N"]
Cc: Dave Hansen <dave.hansen@linux.intel.com>
Signed-off-by: Lubomir Rintel <lkundrak@v3.sk>
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>
diff --git a/drivers/firewire/ohci.c b/drivers/firewire/ohci.c
index 6aa8a86..036fb3b 100644
--- a/drivers/firewire/ohci.c
+++ b/drivers/firewire/ohci.c
@@ -370,6 +370,10 @@
", busReset events = " __stringify(OHCI_PARAM_DEBUG_BUSRESETS)
", or a combination, or all = -1)");
+static bool param_remote_dma;
+module_param_named(remote_dma, param_remote_dma, bool, 0444);
+MODULE_PARM_DESC(remote_dma, "Enable unfiltered remote DMA (default = N)");
+
static void log_irqs(struct fw_ohci *ohci, u32 evt)
{
if (likely(!(param_debug &
@@ -2050,10 +2054,10 @@
be32_to_cpu(ohci->next_header));
}
-#ifdef CONFIG_FIREWIRE_OHCI_REMOTE_DMA
- reg_write(ohci, OHCI1394_PhyReqFilterHiSet, ~0);
- reg_write(ohci, OHCI1394_PhyReqFilterLoSet, ~0);
-#endif
+ if (param_remote_dma) {
+ reg_write(ohci, OHCI1394_PhyReqFilterHiSet, ~0);
+ reg_write(ohci, OHCI1394_PhyReqFilterLoSet, ~0);
+ }
spin_unlock_irq(&ohci->lock);
@@ -2587,13 +2591,13 @@
static int ohci_enable_phys_dma(struct fw_card *card,
int node_id, int generation)
{
-#ifdef CONFIG_FIREWIRE_OHCI_REMOTE_DMA
- return 0;
-#else
struct fw_ohci *ohci = fw_ohci(card);
unsigned long flags;
int n, ret = 0;
+ if (param_remote_dma)
+ return 0;
+
/*
* FIXME: Make sure this bitmask is cleared when we clear the busReset
* interrupt bit. Clear physReqResourceAllBuses on bus reset.
@@ -2622,7 +2626,6 @@
spin_unlock_irqrestore(&ohci->lock, flags);
return ret;
-#endif /* CONFIG_FIREWIRE_OHCI_REMOTE_DMA */
}
static u32 ohci_read_csr(struct fw_card *card, int csr_offset)