mmc: core: Add DT bindings for eMMC hardware reset support
Sometime only need set MMC_CAP_HW_RESET for one of MMC hosts,
So set it in device tree is better.
Signed-off-by: Chaotian Jing <chaotian.jing@mediatek.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/Documentation/devicetree/bindings/mmc/mmc.txt b/Documentation/devicetree/bindings/mmc/mmc.txt
index 0384fc3..f693baf 100644
--- a/Documentation/devicetree/bindings/mmc/mmc.txt
+++ b/Documentation/devicetree/bindings/mmc/mmc.txt
@@ -37,6 +37,7 @@
- sd-uhs-sdr104: SD UHS SDR104 speed is supported
- sd-uhs-ddr50: SD UHS DDR50 speed is supported
- cap-power-off-card: powering off the card is safe
+- cap-mmc-hw-reset: eMMC hardware reset is supported
- cap-sdio-irq: enable SDIO IRQ signalling on this interface
- full-pwr-cycle: full power cycle of the card is supported
- mmc-ddr-1_8v: eMMC high-speed DDR mode(1.8V I/O) is supported
diff --git a/drivers/mmc/core/host.c b/drivers/mmc/core/host.c
index 970e690..da950c4 100644
--- a/drivers/mmc/core/host.c
+++ b/drivers/mmc/core/host.c
@@ -267,6 +267,8 @@
host->caps |= MMC_CAP_UHS_DDR50;
if (of_property_read_bool(np, "cap-power-off-card"))
host->caps |= MMC_CAP_POWER_OFF_CARD;
+ if (of_property_read_bool(np, "cap-mmc-hw-reset"))
+ host->caps |= MMC_CAP_HW_RESET;
if (of_property_read_bool(np, "cap-sdio-irq"))
host->caps |= MMC_CAP_SDIO_IRQ;
if (of_property_read_bool(np, "full-pwr-cycle"))