gpio: stmpe: Write int status register only when needed
On STMPE801/1801 datasheets, it's mentionned writing
in interrupt status register has no effect, bits are
cleared when reading.
Signed-off-by: Amelie DELAUNAY <amelie.delaunay@st.com>
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
index fdac5d9..5806af5 100644
--- a/drivers/gpio/gpio-stmpe.c
+++ b/drivers/gpio/gpio-stmpe.c
@@ -371,12 +371,16 @@
stat &= ~(1 << bit);
}
- stmpe_reg_write(stmpe, statmsbreg + i, status[i]);
-
- /* Edge detect register is not present on 801 and 1801 */
- if (stmpe->partnum != STMPE801 || stmpe->partnum != STMPE1801)
+ /*
+ * interrupt status register write has no effect on
+ * 801 and 1801, bits are cleared when read.
+ * Edge detect register is not present on 801 and 1801
+ */
+ if (stmpe->partnum != STMPE801 || stmpe->partnum != STMPE1801) {
+ stmpe_reg_write(stmpe, statmsbreg + i, status[i]);
stmpe_reg_write(stmpe, stmpe->regs[STMPE_IDX_GPEDR_MSB]
+ i, status[i]);
+ }
}
return IRQ_HANDLED;