DM9000: Remove EEPROM initialisation code.
Remove the old hack to program an initial EEPROM setting
into the DM9000 as we now have ethtool support for reading
and writing the EEPROM.
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/dm9000.c b/drivers/net/dm9000.c
index 2acab02..3bef3b2 100644
--- a/drivers/net/dm9000.c
+++ b/drivers/net/dm9000.c
@@ -191,10 +191,6 @@
static void dm9000_rx(struct net_device *);
static void dm9000_hash_table(struct net_device *);
-//#define DM9000_PROGRAM_EEPROM
-#ifdef DM9000_PROGRAM_EEPROM
-static void program_eeprom(board_info_t * db);
-#endif
/* DM9000 network board routine ---------------------------- */
static void
@@ -699,9 +695,6 @@
ndev->poll_controller = &dm9000_poll_controller;
#endif
-#ifdef DM9000_PROGRAM_EEPROM
- program_eeprom(db);
-#endif
db->msg_enable = NETIF_MSG_LINK;
db->mii.phy_id_mask = 0x1f;
db->mii.reg_num_mask = 0x1f;
@@ -1112,28 +1105,6 @@
mutex_unlock(&db->addr_lock);
}
-#ifdef DM9000_PROGRAM_EEPROM
-/*
- * Only for development:
- * Here we write static data to the eeprom in case
- * we don't have valid content on a new board
- */
-static void
-program_eeprom(board_info_t * db)
-{
- u16 eeprom[] = { 0x0c00, 0x007f, 0x1300, /* MAC Address */
- 0x0000, /* Autoload: accept nothing */
- 0x0a46, 0x9000, /* Vendor / Product ID */
- 0x0000, /* pin control */
- 0x0000,
- }; /* Wake-up mode control */
- int i;
- for (i = 0; i < 8; i++)
- write_srom_word(db, i, eeprom[i]);
-}
-#endif
-
-
/*
* Calculate the CRC valude of the Rx packet
* flag = 1 : return the reverse CRC (for the received packet CRC)