net: use helpers to access uc list V2
This patch introduces three macros to work with uc list from net drivers.
Signed-off-by: Jiri Pirko <jpirko@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c
index d83512d..a7b6b12 100644
--- a/drivers/net/bnx2.c
+++ b/drivers/net/bnx2.c
@@ -48,7 +48,6 @@
#include <linux/cache.h>
#include <linux/firmware.h>
#include <linux/log2.h>
-#include <linux/list.h>
#if defined(CONFIG_CNIC) || defined(CONFIG_CNIC_MODULE)
#define BCM_CNIC 1
@@ -3579,14 +3578,14 @@
sort_mode |= BNX2_RPM_SORT_USER0_MC_HSH_EN;
}
- if (dev->uc.count > BNX2_MAX_UNICAST_ADDRESSES) {
+ if (netdev_uc_count(dev) > BNX2_MAX_UNICAST_ADDRESSES) {
rx_mode |= BNX2_EMAC_RX_MODE_PROMISCUOUS;
sort_mode |= BNX2_RPM_SORT_USER0_PROM_EN |
BNX2_RPM_SORT_USER0_PROM_VLAN;
} else if (!(dev->flags & IFF_PROMISC)) {
/* Add all entries into to the match filter list */
i = 0;
- list_for_each_entry(ha, &dev->uc.list, list) {
+ netdev_for_each_uc_addr(ha, dev) {
bnx2_set_mac_addr(bp, ha->addr,
i + BNX2_START_UNICAST_ADDRESS_INDEX);
sort_mode |= (1 <<