pata_sl82c105: remove un-needed code paths
Remove the DMA setup function. As pointed out by Sergey we set the actual
DMA clock timing in set_dmamode so we don't actually need to do anything
with it at set up time, but just leave the PIO timings loaded.
Signed-off-by: Alan Cox <alan@redhat.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/pata_sl82c105.c b/drivers/ata/pata_sl82c105.c
index 96e890f..0720461 100644
--- a/drivers/ata/pata_sl82c105.c
+++ b/drivers/ata/pata_sl82c105.c
@@ -7,6 +7,13 @@
* SL82C105/Winbond 553 IDE driver
*
* and in part on the documentation and errata sheet
+ *
+ *
+ * Note: The controller like many controllers has shared timings for
+ * PIO and DMA. We thus flip to the DMA timings in dma_start and flip back
+ * in the dma_stop function. Thus we actually don't need a set_dmamode
+ * method as the PIO method is always called and will set the right PIO
+ * timing parameters.
*/
#include <linux/kernel.h>
@@ -19,7 +26,7 @@
#include <linux/libata.h>
#define DRV_NAME "pata_sl82c105"
-#define DRV_VERSION "0.2.3"
+#define DRV_VERSION "0.2.5"
enum {
/*
@@ -126,33 +133,6 @@
}
/**
- * sl82c105_set_dmamode - set initial DMA mode data
- * @ap: ATA interface
- * @adev: ATA device
- *
- * Called to do the DMA mode setup. This replaces the PIO timings
- * for the device in question. Set appropriate PIO timings not DMA
- * timings at this point.
- */
-
-static void sl82c105_set_dmamode(struct ata_port *ap, struct ata_device *adev)
-{
- switch(adev->dma_mode) {
- case XFER_MW_DMA_0:
- sl82c105_configure_piomode(ap, adev, 0);
- break;
- case XFER_MW_DMA_1:
- sl82c105_configure_piomode(ap, adev, 3);
- break;
- case XFER_MW_DMA_2:
- sl82c105_configure_piomode(ap, adev, 4);
- break;
- default:
- BUG();
- }
-}
-
-/**
* sl82c105_reset_engine - Reset the DMA engine
* @ap: ATA interface
*
@@ -222,7 +202,7 @@
/* This will redo the initial setup of the DMA device to matching
PIO timings */
- sl82c105_set_dmamode(ap, qc->dev);
+ sl82c105_set_piomode(ap, qc->dev);
}
static struct scsi_host_template sl82c105_sht = {
@@ -246,7 +226,6 @@
static struct ata_port_operations sl82c105_port_ops = {
.port_disable = ata_port_disable,
.set_piomode = sl82c105_set_piomode,
- .set_dmamode = sl82c105_set_dmamode,
.mode_filter = ata_pci_default_filter,
.tf_load = ata_tf_load,